Safety Instructions GEM80-400
Page iv ALSPA GEM80-400 SERIES CONTROLLERS TECHNICAL MANUAL Issue 3 04//99
The product complies with the safety and EMC standards listed in the
Specifications section of the manual.
The technical data and the information concerning the supply conditions should
be taken from the rating plate and this manual, and must be strictly observed.
3. Transportation and storage.
The instructions for storage and transport specified on the packaging and in this
manual must be followed.
The climatic conditions should be within the limits specified in this manual.
4. Erection and commissioning.
Erection and commissioning of, and cooling medium flow to, the product should
be in accordance with the specifications given in the manual.
Erection and commissioning of the product must be carried out in line with any
local electrical installation and wiring standards and IEC 364 or (in the United
Kingdom) BS 7671.
The earth terminal must be connected to earth (safety ground) in accordance
with local safety regulations and IEC 364-5-54.
The products must be protected against excessive mechanical stresses. In
particular, no component must be bent or isolation distances altered during the
transportation, handling, installation or maintenance of the product.
The degree of protection provided by the covers is for indoor use only.
Compliance with the requirements of EMC laws is the responsibility of the installer
or the manufacturer of the machine. Instructions for erection and commissioning
the product in accordance with the EMC requirements of the European Union
are given in the manual and must be complied with. These instructions contain
information on screening (shielding), earthing (grounding), wiring and relative
positioning of electrical equipment.
Shrouds may be modified only as described in the manual.
5. Electrical connection
When working on the product, the local health and safety legislation must be
observed.
Conductors, protective devices etc. should be provided in accordance with the
requirements stated in the manual.
6. Operation
To Next Page
Loading...
Need help?
General