Flush Panel Mounting
P15D supports flush panel mounting and can be mounted into panels using fitting clamps with M5 X
10 screws.
The fitting clamp and screws are supplied along with the relay.
For mounting the relay in to the panel follow this procedure
1. By loosening the M5 x 10 screws, remove the fitting clamps on the relay and then insert the
Relay in to the panel cutout as show below.
Figure 1: Inserting relay in to the panel cutout
2. After inserting the Relay in the Panel using the Fitting clamps and the M5 x 10 Screws fasten
the relay to the Panel as shown below.
To Next Page
Loading...
