Alstom MiCOM P50 Agile P15D - Page 205

P50 Agile P15D
13 Installation
P15D/EN TM/B
13-19
Cleaning
Warning: Before cleaning the IED, ensure that all AC and DC supplies
and transformer connections are isolated to prevent any
chance of an electric shock while cleaning.
Only clean the equipment with a lint-free cloth dampened with clean water. Do not use detergents,
solvents or abrasive cleaners as they may damage the product's surfaces and leave a conductive
residue.
2.4 Troubleshooting
The relay continuously monitors the hardware and detects any hardware fault/error. In case of
hardware failure relay displays the corresponding error code on the LCD. These faults errors are
stored in the error log file and can be viewed from “Error Log” menu. Error log is stored in 16 bit
integer. The bit definition applicable to P15D is as under:
Bit 10 -
15
Bit 9 Bit 8 Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Unused Unused Fram 3
Error
Unused Fram 2
Error
Fram 1
Error
ADC
Error
Unused RTC Error Unused Setting
Error
Error code descriptions are given below:
Sr. No Error Log
Display
Error Data
Bitwise
Description Causes Action taken
MCU
Proposed action
1 1 0000 0000
0000 0001
SETTING ERROR
1. Setting
corrupted
2. Change in
address of
setting in
memory
ON LED Blinks with 1
sec interval indicating
IED is OUT OF
SERVICE
Go to
CONFIGURATION
menu and restore
default all settings and
then save settings
.Press (RESET +
PROT. RESET).
2 4 0000 0000
0000 0100
RTC ERROR 1. I2C Bus Error
2. Damaged RTC
3. Battery backup
not functioning
Error is checked
periodically after 1
minute interval.
Set correct values for
Date and Time and
Press (RESET +
PROT. RESET).
3 16 0000 0000
0001 0000
ADC ERROR
1. ADC device not
working.
2. SPI bus error
ON LED blinks with 1
sec interval indicating
IED is OUT OF
SERVICE
Press (RESET +
PROT. RESET)
4 32 0000 0000
0010 0000
Fram 1 Error 1. SPI bus error
2. Fram not
working
Error is checked
periodically after 1
minute interval.
Press (RESET +
PROT. RESET)
5 64 0000 0000
0100 0000
Fram 2 Error 1. SPI bus error
2. Fram not
working
Error is checked
periodically after 1
minute interval.
Press (RESET +
PROT. RESET)
6 256 0000 0001
0000 0000
Fram 3 Error 1. SPI bus error
2. Fram not
working
Error is checked
periodically after 1
minute interval.
Press (RESET +
PROT. RESET)