Need help?Do you have a question about the Alta Motors Redshift MX 2017 and is the answer not in the manual?
General| Brand | Alta Motors |
|---|---|
| Model | Redshift MX 2017 |
| Category | Scooter |
| Language | English |
Overview of initial setup and basic controls of the motorcycle.
Procedures for routine checks and adjustments to ensure proper function.
Procedure for removing and installing the motorcycle seat.
Steps for removing and installing the side shrouds.
Procedure for removing and installing the front fender.
Procedure for removing and installing the front number plate.
Procedure for removing and installing the subframe.
Procedure for removing and installing the rear number plate.
Steps for removing and installing the rock guard.
Procedure for removing and installing the mud flap.
Procedure for removing and installing the rear fender.
Procedure for replacing front brake pads on MX models.
Procedure for replacing front brake pads on SM models.
Procedure for replacing rear brake pads on MX and SM models.
Procedure for removing and installing the front MX brake caliper.
Procedure for removing and installing the front SM brake caliper.
Procedure for removing and installing the rear MX/SM brake caliper.
Detailed instructions for overhauling the brake caliper.
Procedure for removing and installing the front brake master cylinder.
Procedure for removing and installing the rear brake master cylinder.
Detailed instructions for overhauling the brake master cylinder.
Instructions for bleeding the brake hydraulic system.
Procedure for removing and installing the brake lever.
Procedure for removing and installing the brake pedal.
Procedure for removing and installing the brake disc.
Procedure for replacing wheel seals and bearings.
Procedure for removing and installing the front wheel.
Procedure for removing and installing the rear wheel.
Procedure for removing and installing the handlebar and mounts.
Instructions for replacing handlebar grips.
Procedure for removing and installing the front forks.
Instructions for adjusting suspension settings.
Procedure for removing and installing triple clamps and steering stem.
Service and repair of steering head bearings and stem.
Procedure for removing and installing the rear shock absorber.
Service and installation of the shock linkage.
Service and installation of the swingarm and its bearings.
Procedure for removing and installing the drive chain.
Procedure for draining and refilling the coolant.
Procedure for removing and installing the coolant pump.
Procedure for replacing coolant hoses.
Critical safety warnings for high voltage system handling.
Overview of the high voltage battery and drive system operation.
Procedure for removing and installing the HV battery connector.
Procedure for removing and installing the battery.
Procedure for removing and installing the charge inlet.
Procedure for removing and installing the DC Charge Port.
Procedure for removing and installing the Accessory Control Module.
Procedure for removing and installing the motor controller.
Procedure for removing and installing the primary drive sprocket.
Procedure for replacing the output shaft seal.
Procedure for removing and installing the timing cover.
Procedure for removing and installing the position sensor.
Procedure for removing and installing the gearbox cover.
Procedure for removing and installing drive and driven gears.
Procedure for removing and installing the motor and output shaft.
Procedure for replacing the right-side countershaft bearing.
Procedure for replacing the left-side countershaft bearing.
Procedure for removing and installing the skidframe.
Procedure for removing and installing the boot guards.
Procedure for removing and installing the footpegs.
Procedure for removing and installing the sidestand.
General information and servicing for the frame bulkheads.
Procedure for removing and installing the display unit.
Procedure for removing and installing the start/stop/run switch.
Procedure for removing and installing the map switch.
Procedure for removing and installing the ignition switch.
Procedure for removing and installing turn signal/horn/hi-lo beam switch.
Procedure for removing and installing the throttle switch and tube.
Procedure for removing and installing brake light switches.
Procedure for removing headlight housing and replacing bulb.
Procedure for adjusting the headlight aim.
Information on the marker light.
Information on the taillight.
Procedure for replacing turn signal and running light bulbs.
Information on the license plate light.
To Next Page