Altec Lansing INMOTION IM600 User Manual (English)

Other manuals for Altec Lansing INMOTION IM600

Questions and Answers:

D
Devon GreenJul 30, 2025
Why is my Altec Lansing Speaker System making a crackling sound?
- C
  Carlos StoneJul 30, 2025
  If you hear a crackling sound from your Altec Lansing Speaker System, consider these potential causes: * If you're using an iPod, it might not be correctly seated in the docking station. Turn off the iPod, remove it, reseat it, and turn it on again. * If you're using an alternate audio source, the connection to the inMotion iM600 might be faulty, or there could be an issue with the audio source itself. Connect the audio source to the AUX input on the back of the inMotion iM600 using a 3.5mm stereo cable. Set the volume on the audio source at mid-level, and adjust the volume on the inMotion iM600 from minimum to a comfortable listening level.
T
Tami KennedyAug 5, 2025
What to do if Altec Lansing inMotion iM600 controls do not function?
- D
  daviesjeremyAug 5, 2025
  If your Altec Lansing inMotion iM600 is behaving erratically or the controls aren't working, it might be due to static electricity, a momentary power interruption, or abnormal operating conditions. Here's what you can do: 1. Disconnect the power supply from the wall outlet. 2. Disconnect the rechargeable battery per instructions in the “Power” section. 3. Wait 20–30 seconds. 4. Reconnect the rechargeable battery. 5. Reconnect the power supply.
R
Roy CampbellAug 10, 2025
Why is there crackling sound from Altec Lansing Speaker System when connected to PC?
- L
  luis19Aug 10, 2025
  If you're hearing a crackling sound from your Altec Lansing Speaker System when it's connected to a PC or laptop, the operating system’s volume level might be set too high. Check the operating system volume level and decrease it if necessary.
D
David NguyenAug 14, 2025
How to stop radio interference on Altec Lansing Speaker System?
- O
  Olivia PowellAug 15, 2025
  If you are experiencing radio interference with your Altec Lansing Speaker System, the unit may be too close to a radio tower. Try moving the unit to see if the interference goes away.
B
brandonmckeeAug 20, 2025
How to stop intermittent buzzing on Altec Lansing Speaker System?
- K
  Kathryn ReedAug 20, 2025
  If you're experiencing intermittent buzzing with your Altec Lansing Speaker System, the unit might be located too close to a GSM cell phone. Move the GSM cell phone away from the unit.