6 of 6
749-50092
Section 3:Max Out and Low Speed Calibration
The Max Out (MX) and Low Speed (LMX) settings for the boom, winch, and digger
functions must be properly adjusted to achieve the correct valve spool travel and cycle
times at full control handle travel. Because the MX and LMX calibration procedures vary
for different models, refer to the latest CADI Quick Reference Guide (p/n 749-30200) or
the appropriate maintenance manual for the proper procedures.
1. After all testing and adjustments are completed, engage the unit’s hydraulic system
and operate the unit in all functions looking for leaks and proper operation. Make any
corrections necessary.
2. Stow the unit. Retract the outriggers. Disengage the hydraulic system and return the
unit to service.
8-23-13
Section 3
Testing and
Completion
To Previous Page