2018 FORD F-150 5.0L COMPRESSED NATURAL GAS CONVERSION SYSTEM INSTALLATION INSTRUCTIONS
2018 F-150 5.0L INSTALLATION MANUAL
Page 10
• Connect low pressure fuel hose to the regulator. Torque to 30-35 ft-lbs. See low pressure hose install section for details.
• Connect rear wire harness to the high pressure sensor and electric cylinder valve. See wire harness install section for details.
• Connect coolant hoses to the regulator once hoses are routed. See coolant hose install section for details.
Note: Once Low Pressure hose, Rear Harness, and Coolant hoses have been routed, secure them with a zip tie near the grom-
met to eliminate any slack in the lines.
Low pressure connection. Rear harness connection. Coolant hoses connection.
CYLINDER INSTALL - 6.5’ SHORT BED / 8’ LONG BED
To Next Page
Loading...