2018 FORD F-150 5.0L COMPRESSED NATURAL GAS CONVERSION SYSTEM INSTALLATION INSTRUCTIONS
2018 F-150 5.0L INSTALLATION MANUAL
Page 25
1. Below the steering column, mark 3 sides of the insulation and cut to accommodate a
7/8” hole.
This hole will be used for the harness leading into the engine compartment.
2. Drill a 7/8” hole. Rust proof and de burr.
3. Feed the gauge harness through the hole and into the engine compartment.
Secure the harness grommet.
4. Attached to the main CNG harness
FUEL GAUGE ROUTING and INSTALL
1
1
2 3
To Next Page
Loading...