57
Please insert the battery (CR 2032) into the battery com-
partment. ATTENTION! Do not touch the battery with bare
hands!
Install the casing cover – Now supply operation voltage to
the Wireless Basis (AL-B2070), if this has not already been
performed. After this, the assignment „Heating zone – Wire-
less Thermostat“ can be performed. The assignment should
be performed from the installation place of the thermostat.
After activating the learning mode on the basis station
(see manual), the desired heating zone can be assigned
by pressing the SET button on the thermostat; this will
send a logon code to the basis. Label the thermostat and
subsequently fit the set value element.
To Next Page
