14 15
hEart ratE mEaSUrEmEnt
On the main menu, tap on the HR icon to enter the heart
rate interface. It will vibrate once the measurement has
nished and the data will be displayed.
For accurate measurements, ensure the following:
• The smart watch has good contact with your wrist.
• Check that the sensor is clean and there is no dirt or
debris covering it.
• It may take over 30 seconds before the rst result is
shown on the screen.
Blood PrESSUrE
On the main menu, tap on the Blood Pressure (BP) icon
to enter the blood pressure interface. It will vibrate
once the measurement has nished and the data will be
displayed. Tap the measure icon on the app to start a
new measurement.
Blood oxyGEn
On the main menu, tap on the Blood Oxygen (SPO2)
icon to enter the blood oxygen interface. It will vibrate
once the measurement has nished and the data will be
displayed. Tap the measure icon on the app to start a
new measurement.
For accurate measurements for heart rate, blood pressure
and blood oxygen, ensure the following:
• The smart watch has good contact with your wrist.
• Check that the sensor is clean and there is no dirt or
debris covering it.
• It may take over 30 seconds before the rst result is
shown on the screen.
Note: The results and measurements of heart rate, blood
pressure and blood oxygen data cannot be used for
medical reference and should be used as a guide only.
camEra (rEmotE caPtUrE)
On the Da Fit app, make sure the watch is connected.
On the main menu, tap on the camera to use the watch
as a camera remote for your phone. Tap the camera icon
again (you can also tap “shutter” on the app). Tap the
icon on the watch screen to remotely take a photo.
BriGhtnESS
On the main menu, tap on the brightness icon to adjust
the screen brightness of the watch. Swipe right to exit to
the main menu and save the brightness setting.
To Next Page
Loading...