Alto-Shaam 1000-BQ2/96

10 MN-29578 • Rev 6 • 04/17 • 1000-BQ2 Banquet Cart
Electrical Connection
1. An identication tag is permanently mounted on the
cabinet.
2. Plug cabinet into a properly grounded receptacle only,
positioning the unit so the power supply cord is easily
accessible in case of an emergency.
3. If necessary, a proper receptacle or outlet
conguration as required for this unit, must be
installed by a licensed electrician in accordance with
applicable, local electrical codes.
WARNING
To prevent serious injury, death, or
property damage:
All electrical connections must be
made by a qualified and trained service
technician in accordance with applicable
electrical codes.
This appliance must be adequately
grounded in accordance with local
electrical codes or, in the absence of local
codes, with the current edition of the
National Electrical Code ANSI/NFPA No.
70. In Canada, all electrical connections
are to be made in accordance with CSA
C22.1, Canadian Electrical Code Part 1 or
local codes.
CE-approved appliances include an
equipotential-bonding terminal marked
with the symbol shown on the le .
Provisions for earthing are to be made in
accordance with IEC:2010 60335-1 section
27 or local codes.
WARNING
To prevent SERIOUS INJURY, DEATH or
PROPERTY DAMAGE:
All electrical connections must bemade
bya qualified and trained service
technician in accordance with applicable
electrical codes.
Hard wired models:
Hard wired models must be equipped with a country
certi ed external allpole disconnection switch with
suf cient contact separation.
If a power cord is used for the connection of the product an
oil resistant cord like H05RN or H07RN or equivalent must
be used.
CAUTION
Power source must match voltage identified
on appliance rating tag. The rating tag
provides essential technical information
required for any appliance installation,
maintenance or repairs. Do not remove,
damage or modify the rating tag.
NOTICE: Where local codes and CE regulatory
requirements apply, appliances must be
connected to an electrical circuit that is
protected by an external GFCI outlet.