Need help?Do you have a question about the Alto zmx244fx and is the answer not in the manual?
Mono Input Channels| frequency response | 20 Hz – 20 kHz, ±1 dB |
|---|---|
| THD+N | 0.03% at 0 dBu, 1 kHz |
| gain range | 0 dB to 50 dB (MIC) |
| SNR | 114 dB |
Stereo Input Channels| frequency response | 20 Hz – 20 kHz, ±1 dB |
|---|---|
| THD+N | 0.03% at 0 dBu, 1 kHz |
Impedances| microphone inputs | 1.4 kΩ |
|---|---|
| channel insert return | 2.5 kΩ |
| 2-Track outputs | 1 kΩ |
Equalization| high-shelving | ±15 dB @ 12 kHz |
|---|---|
| mid bell (mono) | ±12 dB (frequency range 100 Hz ~ 8 kHz) |
| low-shelving | ±15 dB @ 80 Hz |
DSP Section| A/D & D/A converters | 24-bit |
|---|---|
| DSP Resolution | 24-bit |
| max delay time | 650 ms |
Main Mix| noise (bus noise) | -90 dBr (ref: +4 dBu) |
|---|---|
| max output | +22 dBu balanced XLR |
| aux returns gain range | -∞ to +15 dB |
Power Supply| main voltage USA/Canada | 100-120 VAC ~ 60 Hz |
|---|---|
| main voltage UK/Australia | 240 VAC ~ 50 Hz |
| power consumption | 70 W |
Weight and Dimensions| dimensions (W x D x H) | 30.1" x 15.7" x 4.5" (765 mm x 400 mm x 115 mm) |
|---|---|
| weight | 23.4 lbs (10.6 kg) |
Details on power connection, switches, and various audio output/input jacks on the rear panel.
Covers insert points, auxiliary sends/returns, direct outs, and subgroup connections for signal processing.
Explains the USB port for computer connection and the footswitch jack for effect control.
Describes microphone and line inputs, insert points, gain control, and low-cut filtering for channels.
Details the EQ controls, auxiliary send volume, and pre/post-fader switching for channel signal routing.
Covers pan/balance, peak indication, fader, mute, assignment to subgroups/main mix, and solo functions.
Details additional channel features including 2-track, effects, and USB input selection for specific channels.
Explains controls for effects out volume, aux returns, main mix fader, solo mode, and master volume for headphones/control room.
Guide on selecting and applying effects, adjusting parameters like decay time, pre-delay, and delay period.
Details frequency response, THD+N, gain range, and SNR for mono and stereo input channels.
Lists impedance values for various inputs and the frequency ranges and levels for equalization controls.
Covers DSP section capabilities, main mix output levels, noise, and power supply requirements.
To Next Page
