Altrad Belle RTX 50 - User Manual

Questions and Answers

H
holly65Aug 12, 2025
Why Altrad Belle RTX 50 Construction Equipment engine will not start?
- B
  Bridget MillerAug 12, 2025
  Your Altrad Belle Construction Equipment engine might fail to start due to several reasons. It could be due to lack of fuel, in which case you should fill the fuel tank. Another reason might be that the fuel tap is closed; open it. If you have a GX100 engine, it might not be primed, so push the Carburettor Primer Bulb 4 times. If you have a petrol engine, the spark plug may be contaminated or damaged, so replace it. Finally, a faulty Carburettor could also be the reason, so service the Carburettor.
A
amy24Aug 19, 2025
What to do if Altrad Belle RTX 50 engine runs, but machine does not produce impact?
- F
  flowersdanielAug 19, 2025
  If the engine of your Altrad Belle Construction Equipment runs but the machine doesn't produce impact, it might be due to lack of engine power. Another cause may be a slipping clutch. Clean the shoe and drum with a proper solvent, and replace the clutch shoe if necessary.
T
Tammy WiseAug 27, 2025
What to do if Altrad Belle Construction Equipment engine runs, but the machine does not produce impact?
- L
  ljohnsonAug 27, 2025
  If your Altrad Belle Construction Equipment engine runs but the machine doesn't produce impact, it could be due to a lack of engine power. Also, the clutch might be slipping, so clean the shoe and drum with a proper solvent and replace the clutch shoe if needed. If the crank mechanism is damaged, you should contact your dealer.
M
Megan RoachSep 4, 2025
Why Altrad Belle Construction Equipment engine stops suddenly?
- D
  Debra FernandezSep 4, 2025
  If your Altrad Belle Construction Equipment engine stops suddenly or when the engine RPM is increased, it might be because the main jet of the Carburettor is clogged with dirt (GX120 Only). In this case, take out the main jet of the Carburettor and clean it with compressed air. If you have a petrol engine, the spark plug cap might be loose, so tighten the cap to the plug.