Altrad BELLE RPC 60/80

Questions and Answers

M
Michael AdamsAug 4, 2025
How to start Altrad Construction Equipment when the engine will not start?
- T
  Tammy DavisAug 4, 2025
  If the Altrad Construction Equipment engine won't start, there could be several reasons. First, check if the fuel tap is open and that the fuel tank is full. Then switch the engine on. A fouled spark plug could also be the culprit; try cleaning and resetting the plug gap. If the engine is cold, close the choke. Pull the recoil starter until the engine fires. If that doesn't work, move the speed control to stop, pull the recoil starter three times, and then repeat the start procedure.
D
David GarrettAug 9, 2025
What to do if Altrad Construction Equipment unit will not move?
- M
  Michele ColeAug 9, 2025
  If your Altrad Construction Equipment unit won't move, it might be due to a slow engine speed; set the engine speed control to fast. Also, check if the drive belt tension is loose and adjust it accordingly. Ensure the air filter is clean or renew it if needed. A worn or damaged clutch could also be the reason, so repair or replace it as necessary.
V
Valerie KimAug 13, 2025
Why is Altrad Construction Equipment losing hydraulic oil?
- E
  erin44Aug 13, 2025
  If you notice a loss of hydraulic oil in your Altrad Construction Equipment, check for leaking connectors and reseal them. Also, inspect the hydraulic hose for defects and replace it if necessary.
C
Crystal ReyesAug 19, 2025
Why is the reverse speed of my Altrad Construction Equipment too slow?
- L
  Laura AguilarSep 12, 2025
  If the reverse speed of your Altrad Construction Equipment is too slow, it could be due to insufficient oil in the hydraulic head; fill and bleed the system. Additionally, check for air in the control system and bleed it.
R
Ryan SchwartzAug 25, 2025
Why is the forward speed of my Altrad Construction Equipment too slow?
- C
  coltonpadillaAug 25, 2025
  If the forward speed of your Altrad Construction Equipment is too slow, it might be because there's too much oil in the hydraulic head. Try reducing the oil level.
J
jade92Aug 28, 2025
Why does Altrad Construction Equipment operate erratically?
- S
  Scott BakerAug 28, 2025
  If your Altrad Construction Equipment operates erratically, the shock mounts might be damaged. Replace all four mounts.