- 4 -
MANUAL FOR DM MOTORS, SERIES S
" In accordance with the provisions of the Directive of the European Parliament and of the Council 2012/19 / EU of 4 July 2012 on waste
electrical and electronic equipment (WEEE), it is prohibited to place of used equipment
together with other wastes, marked with crossed
The users are obliged to transfer their used equipment to a designated collection point for proper processing.
The marking means, at the same time, that the equipment was put on the
market after 13 August 2005.
These legal obligations have been introduced to reduce the amount of waste generated from waste electrical and electronic equ
ipment
and to ensure an appropriate level of collection, recovery and recycling. The equipment does not contain any dangerous components,
which would have any particularly negative impact on the environment and human health."
Production plant in Opole
ul. Gosławicka 3, 45-446 Opole, Poland
tel. +48 77 40 00
000, fax. +48 77 40 00 006
e-mail: Aluprof@aluprof.eu
- power supply: 230 VAC / 50 Hz
- mechanical limit swiches
- maximum time of continous work: 4 min.
- operating temperature:
~ -25
o
C ~ +50
o
C (protection degree IP44)
The manufacturer reserves a margin tolerance
with respect to the catalogue data due to use
in a variety of conditions.
Headquarters; Production plant in Bielsko-Biała
Warszawska 153, 43-300 Bielsko-Biała, Poland
+48 33 81 95 300, fax. +48 33 82 28 512
MANUAL FOR DM MOTORS, SERIES S
- Installation of the motor should be carried out by authorized persons
- The motor is designed for use in dry rooms and should not be exposed to direct weather conditions.
- The motor should be powered by a separate circuit and protected by a quick fuse for example: circuit breaker type B10
To Next Page
Loading...
Need help?
General
