Aluprof DM45RM User Manual

- 6 -
PROGRAMING MANUAL FOR DM MOTORS, SERIES RM
" In accordance with the provisions of the Directive of the European Parliament and of the Council 2012/19 / EU of 4 July 2012 on
waste electrical and electronic equipment (WEEE), it is prohibited to place of used equipment together with other wastes, mar
ked
with crossed out wheeled bin symbol.
The users are obliged
to transfer their used equipment to a designated collection point for
proper
processing. The marking means, at the same time, that the equipment was put on the market after 13 August 2005.
These legal obligations have been introduced to reduce the amount of waste generated from waste electrical and electronic
equipment and to ensure an appropriate level of collection, recovery and recycling. The equipment does not contain any danger
ous
components, which would have any particularly negative impact on the en
vironment and human health."
Production plant in Opole
ul. Gosławicka 3, 45-446 Opole, Poland
tel. +48 77 40 00
000, fax. +48 77 40 00 006
e-mail: Aluprof@aluprof.eu
Headquarters; Production plant in Bielsko-Biała
Warszawska 153, 43-300 Bielsko-Biała, Poland
+48 33 81 95 300, fax. +48 33 82 28 512
PROGRAMING MANUAL FOR DM MOTORS, SERIES RM
Technical data
- power supply: 230 VAC / 50 Hz
- mechanical limit swiches
- bulid in radio receiver
- frequency transmission rate: 433.92MHz
- output power: 10 milliwatts (mW)
- operating temperature: ~ -10
o
C ~ +50
o
C (protection
degree IP44)
- transmission distance: 200 meters (open area)
35 meters (built-up area)
- ability to store up to 20 channels in one tubular
motor. Each next channel will erase the first one
All DC series transmitters available in the ALUPROF
offer are suitable for the radio control.
The manufacturer reserves a margin tolerance with
respect to the catalogue data due to use in a variety of
conditions.
NOTE
- Installation of the motor should be carried out
by authorized persons
- The motor is designed for use in dry rooms
and should not be exposed to direct weather
conditions.
- The motor should be powered by a separate circuit
and protected by a quick fuse for example: circuit
breaker type B10
Electrical connections
Power 230V / 50 Hz

Aluprof DM45RM Specifications

General

Brand	Aluprof
Model	DM45RM
Category	Engine
Language	English