Aluprof DM45RM User Manual

- 9 -
x2 BIP
Press the button "P2” twice of the
already programmed transmitter
and you will hear an acoustic signal
(x2 BIP)
Press the ”P2” button of the
new transmitter
After successful setup the radio
receiver will beep (x5 BIP)
4. Memorizing another transmitter
OK
x1 BIP
x3 BIP
After successful setup the radio receiver will
beep (x3 BEEP) and move up-down.
The device will switch into operation
mode without support, repeat the
programming sequence to return to the
operation mode with support
Press the "P2" button
Press the "UP" button and you
will hear an acoustic signal
(x1 BIP)
Press the "P2" button and you
will hear an acoustic signal
(x1 BIP)
x1 BIP
5. Function with support or without support
After successful setup the radio
receiver will beep (x3 BEEP)
X3 BIP
Press the "P2" button and you will
hear an acoustic signal (x1 BEEP)
x1 BIP
Press the "STOP" button and you
will hear an acoustic signal (x1 BIP)
x1 BIP
Press the "P2" button
6. Ereasing the memory of the motor
To clean up emiter means deleting all the memory of emiter in the motor receivers

Aluprof DM45RM Specifications

General

Brand	Aluprof
Model	DM45RM
Category	Engine
Language	English