- 5 -
Instruction for montage of outside roller shutters in
ADAPTING system, type SK
and in
ADAPTING system, type SK with MOSKITO.
SK_+_moskito_m_uk
We reserve the right to any technical change. Valid on: 2009-06-02
11
12
13
15
16
14
I ADAPTING ROLLER SHUTTER SYSTEM SK – ASSEMBLY IN RECESS
The order of assembly
a) Check the dimensions of the construction’s hole [11], [12].
b) Mark the position of the drilling hole for the strap or rope of manual drive (about 17mm above the edge of the guide
channel) [13], then drill the hole [14].
- for strap – with the drill Ø 20 ÷ 22 mm (installation tube Ø 20 ÷ 22 mm should be inserted into this hole and the tube
should be cut evenly with the window frame from both inside and outside of the room)
- for rope – with the drill Ø 10 ÷ 13 mm (spring of rope guide should be inserted into hole and its length should be
adjusted to the thickness of window frame.
In the case of electric drive, the hole for the motor’s wire should be drilled in the place where it is planned to carry out
the wiring.
c) Put the roller shutter to the basis [15], place the guide channels vertically and screw them to the window frame [16].
To Next Page
Loading...