4
OPERATION OF THE
HEATER
NOTE: It is normal when
the heater is switched on
for the rst time or when it
is turned on after having not
been used for a long period
of time, the heaters may
emit some smell and fumes.
This will disappear when the
heater has been on for a
short while.
Before using the heater,
make sure you understand
the “IMPORTANT SAFETY
INFORMATION”
section of this manual.
1. Place the radiator body upside-down on a scratch-free
surface, make sure it is stable and will not fall.
2. Screw off the wing nuts from the U-shaped bolt provided,
attach the U-shaped bolt to the U-facing
ange between rst and second ns (near the front cover).
3. To attach the castor mounting plate to the radiator body, you
should insert the threaded ends of the U-bolt in the holes on the
castor mounting plate.
4. Screw the wing nuts back to the U bolt and fasten the wing nut
properly.
Note: do not over tighten, which may cause the damage to the
radiator ange.
5. Screw o spherical nut from the castor, align the shaft to the hole
of the castor mounting plate, insert, and screw on the spherical
nut.
6. Repeat 2, 3, 4 and 5 on the rear of radiator for mounting of the
rear castors.
Note: the rear castors must be mounted between the end two ns.
To Next Page
Loading...
