Alva EIH200 - Maintenance; Troubleshooting

SWITCHING OFF
Place the switch buttons of the selection knob modes to the
“OFF” position and disconnect the appliance from the electric
mains.
MAINTENANCE
It is necessary to periodically wipe the heater, depending on the
placement and enviroment of its use.
Be sure the heater is fault free:
1. Check that the thermostat can be turned ON and OFF. You
will hear an audible "click".
2. Check the electric mains lead is properly connected.
3. Ensure that the mains lead and plug are not damaged.
• Your heater should be checked once a year by a qualied
technician.
• If faults are suspected or detected, stop using the heater
and contact ALVA.
• Clean the exterior of your heater when required to remove
dust.
• DO NOT use abrasive products to clean the heater; these
may damage the heater surface.
• Always make sure the heater is OFF and cool before
conducting any maintenance.
• Keep young children or inrm persons away from any hot
surfaces.
• Always disconnect the heater from the electricity mains
when not in use, during installation and cleaning.
• DO NOT submerge the heater in water.
• DO NOT spray down or rinse the heater with water.
TROUBLESHOOTING
SYMPTOM CAUSE SOLUTION
Heater will not turn
ON
Not plugged in
Not switched ON
Tilt switch has
activated
Plug in and switch
on socket.
Switch ON
Stand the heater
upright on a level
surface.
5