8
Notes
Accessories
• GO 2 and its accessories contain small objects. Keep them out of children’s reach to
prevent swallowing.
• Avoid using all accessories in high-speed or high-intensity environments, otherwise
your camera or accessories may fall off.
• As thick clothing can weaken the magnetic force of the Magnet Pedant, please do
not use GO 2 with thick clothing and always test GO 2’s stability before shooting.
• If you wear a cardiac pacemaker, do not wear the Magnet Pendant.
• When using the Pivot Stand, please attach it to dry, clean and flat surfaces only.
Avoid attaching it to surfaces with strong vibrations.
• Peel the Pivot Stand off surfaces from the edge of the base. Do not pull it off from
the center.
• If the Pivot Stand has lost stickiness, clean with water and dry for re-use. After use,
place its original cover back on. Avoid sticking the Pivot Stand in high or low
temperature environments.
Updating the firmware:
• Before use, please update the firmware of GO 2 and its charging case.
• Before updating, ensure that both GO 2 and the charging case’s remaining power is
not less than 50 %.
• How to update via your computer (U-disk mode):
Step 1: Download the latest firmware from Insta360’s official website.
Step 2: Use the included charging cable to connect the charging case (with GO 2
placed within) to your computer. Make sure both GO 2 and the charging case are
powered on.
Step 3: Copy the “InstaGo2FW.pkg” file you have downloaded to your GO 2 directly.
Delete the old “pkg” file first if there is one.
Step 4: Disconnect the charging case from your computer and GO 2 will power off
automatically. Close the charging case and open it again, then GO 2 will power on
automatically and start updating the firmware with a slow-flashing cyan light. After
finishing GO 2’s firmware update, the charging case will start to update its firmware
as well. Please keep the charging case open.
• For more information on updating the firmware, visit:
https://onlinemanual.insta360.com/go2/en-us/camera/firmware
To exit U-disk mode, please eject the device from your computer before unplugging
the charging cable.
To Next Page
Loading...