IS-300CA INVERTER POWER SUPPLY
x 990-418
SAFETY PRECAUTIONS
DEATH ON CONTACT may result if personnel fail to observe the safety
precautions labeled on the equipment and noted in this manual.
HIGH VOLTAGE is used in the operation of this equipment.
WHEN WELDING always wear safety glasses.
General
This instruction manual describes the operation and maintenance of the Power Supply and
provides instructions relating to its SAFE use. Procedures described in this manual must
be performed as detailed by QUALIFIED and TRAINED personnel.
For SAFETY, and to effectively take advantage of the full capabilities of the Power Supply,
please read this instruction thoroughly before attempting to use it.
After reading this manual, retain it for future reference when any questions arise regarding
the proper and SAFE operation of the Power Supply.
Operation
Procedures other than those described in this manual or not performed as prescribed in this
manual, may expose personnel to electrical shock or death.
When operating any welder, always wear appropriate personal protective gear.
Maintenance/Service
Before performing any maintenance on the Inverter Power Supply, read Chapter 5,
Maintenance thoroughly. Use the appropriate tools for terminating the connecting cables,
being careful not to nick the wire conductors.
Do not modify the Power Supply without prior written approval from Amada Weld Tech.
To Next Page
Loading...