IS-300CA INVERTER POWER SUPPLY
990-418 iii
FOREWORD
Thank you for purchasing an Amada Weld Tech IS-300CA Inverter Power Supply. This Power Supply
has a wide variety of options, some are installed at the time of purchase, some may be added later. For
the rest of this manual, the IS-300CA will be referred to simply as the Power Supply.
Upon receipt of your equipment, please thoroughly inspect it for shipping damage prior to its installation.
Should there be any damage, please immediately contact the shipping company to file a claim, and notify
us at:
Amada Weld Tech Inc.
1820 South Myrtle Avenue
Monrovia, California 91016
Phone: (626) 303-5676
FAX: (626) 358-8048
E-Mail: info@amadaweldtech.com
The purpose of this manual is to supply operating and maintenance personnel with the information needed
to properly and safely operate and maintain the IS-300CA Inverter Power Supply.
We have made every effort to ensure that the information in this manual is accurate and adequate. The
contents of this manual are subject to change without notice.
Should any questions arise, or if you have suggestions for improvement of this manual, please contact us
at the above location/numbers.
Amada Weld Tech is not responsible for any loss due to improper use of this product.
This manual covers the following models:
IS-300CR BASIC, 200-240V 1-325-01
IS-300CA-BASIC/200-240 1-325-02
IS-300CR BASIC, 380-480V 1-325-01-01
IS-300CA-BASIC/380-480 1-325-02-01
IS-300CR ADV, 200-240V 1-325-01-02
→
IS-300CA-ADV/200-240 1-325-02-02
IS-300CR ADV, 380-480V 1-325-01-03
IS-300CA-ADV/380-480 1-325-02-03
IS-300CR ETHERNET IP, 200-240V 1-325-01-04
IS-300CA-EIP AB/200-240 1-325-02-04
IS-300CR ETHERNET IP, 380-480V
To Next Page
Loading...