Amano MJ-10 - Page 8

－４－
No, Name Quantity Remarks
1
Electric shock caution
sticker
1
2
Power wire caution
sticker
1
Supply power from the machine tool circuit equipped with a protective device.
3
General-purpose PL
nameplate 71 (No. 1)
1
Warning: Read and understand the contents of the operation manual and the label before operating
the unit! Failure to do so can lead to unexpected accidents.
Warning: Do not take in any mist containing oil with a flash point of 80°C and below, sparks, fire, or
other combustible substances. These substances can cause fires or explosions.
Warning: Do not install the unit in hazardous locations prescribed by laws or regulations! Doing so
may result in fire or explosion.
Caution: All maintenance work must be performed by a competent technician familiar with the unit.
Failure to do so can lead to unexpected accidents.
Caution: If abnormal noises, fumes, vibrations or smells are detected during operation, turn off the
power at once. Continuing to operate the unit can cause damage, electric shock, or fire.
4
General-purpose PL
nameplate 71 (No. 2)
2
Caution: Wear gloves before performing an inspection or replacing parts. Failure to do so can cause
injury.
5
General-purpose PL
nameplate 71 (No. 3)
1
Warning: Be sure to ground the unit. Otherwise, electric shock could occur if there is a leak.
6
General-purpose PL
nameplate 71 (No. 4)
1
Warning: Beware of rotating objects. Before opening the cover, turn the power off and make sure the
motor has come to a complete stop. Failure to do so can cause injury.
Caution: Do not look inside the outlet hole! Doing so can cause injury to your eyes or health by
debris or splashes coming out of the outlet hole.
7
General-purpose PL
nameplate 71 (No. 5)
1
Warning: Do not suspend the unit with the frame attached to it. Doing so can cause the frame to fall
or topple.
8
Machine number Plate
1
9
Ground mark
1(2)
MJ-5 and MJ-10 uses 1. MJ-15 and MJ-25 uses 2.