10. Attach optional light ring to the
base of the Kindle neck using the 3
small self tapping screws. Be careful
not to over-tighten these screws as
they may crack the light ring.
11. Place the Kindle base cover over
the weighted base, then slide the heater
assembly into the socket post. If the
optional light ring is installed, be careful
not to damage it during this step.
10.
11.
11.
12. Snap the trim ring (or optional
cocktail table) onto the top portion
of the Kindle Base.
12.
To Next Page
Loading...
Need help?
General
