Intended Use
This product is intended for boiling drinking water.
This product is intended for household use on y. It is not intended for commercial use.
This product is intended to be used in dry indoor areas only.
• No liability wi be accepted for damages resulting from improper use or non-compliance with
these instructions.
Before First Use
• Check for transport damages.
• Cean the product before first use.
• Before connect ng the product to the power supply, check that the power supply voltage and
current rating corresponds with the power supply details shown on the product rating abel.
A DANGER
Risk of suffocation! Keep any packaging materials away from children —these
materials are a potential source of danger, e.g. suffocaton.
Operation
Placing the base
• Use a stable and eve surface for the base (E).
• Wind the excess cable onto the cable winder (F).
• Pass the cable through the cable passage (G).
Connect the plug to a power outlet.
Boiling water
the first batch Of boiled water from the product to make sure any
eftover dust Or elements from manufacturing are eliminated.
Push the lid opening button (J).
Fillthe kettle (C) with water. The water level must be between the MIN and MAX marks.
• Close the lid (K).
• Place the kettle (C) on the base (E).
Push down the switch (H). The LED circle (D) at the bottom Ofthe kettle lights up. The boiling
procedure begins.
The product switches Off automatically when the water is bo'ling.
A CAUTION
Risk of scalding! To prevent water from spilling over, the lid (K) must be closed
when pouring.
6
To Next Page
Loading...