10
Assembly
Step 7:
Setting Up the Product
A
E
B
G
• Put the last shelf
A
onto the poles
B
and lower it down until it rests on the
plastic sleeves
E
. Place cardboard over the corners of each shelf and gently tap
down with a rubber mallet (or similar tool) until the shelf is level.
• To improve stability (if needed), drill two tiny holes (Ø 4 mm) into the wall and
insert the dowels
G
. Secure the shelf to the wall by installing the Furniture Tipping
Restraint hardware. The full instructions are inside the hardware bags.
English Français Deutsch Italiano Español
日本語 中文
the instructions
Wall
To Next Page
Loading...
