7
Intended Use
• This product is intended for boiling water.
Before First Use
When using for the first time or after a lengthy period of disuse, we recommended to fill the product
up to the Max mark (1.0 L), bring to boil, then discard the water and repeat.
This will remove potential extraneous and unwanted residues.
Operation
• Press the lid release button to open the lid.
• Fill the product with water (between the 0.5 L and the 1.0 L marks).
• Close the lid. Place the product on the base.
• Connect the plug to a power outlet. Press the On/Off switch down.
• The light goes on, the product is now heating the water.
• The product will switch off automatically when the water starts boiling. The light will then go out.
• The product features a safety switch that shuts it down if it boils dry. If this should occur, remove it
from the base and wait until it cools down before using it again.
NOTE: The kettle should ONLY be used with the base provided.
Burn Hazard! Do not overfill kettle:
• Water might enter the steam tube and leak from thebottom of the product
• Boiling water might spill out of the spout.
Cleaning and Maintenance
• Regular cleaning will prolong the lifespan of the product.
• Always unplug from the plug socket and allow to cool down before cleaning.
Do not immerse any part of the product in water or other liquid.
•
Do not use chemical or abrasive agents (or tools) to clean the outside of the product. These may
damage the outside surface.
To Next Page
Loading...
Need help?
General