AMB 530 FME - Device Description

5
3. Device description
1
2
Intended use
The built-in milling and grinding motor is intended for milling and grinding work on wood,
plastic and aluminium components. The unit has no restart protection and may therefore only
be operated in a xed installation
(e.g. CNC gantry or milling stand) according to EU regulation. Hand-held or hand-guided use is
therefore not permitted under EU law.
Requirements for the user
The unit may only be operated,
serviced and maintained by authorised, instructed personnel. This person must have read and
understood the operating instructions
and the safety instructions.
1 Union nut
2 Collet chuck
3 Spindle
4 Spindle lock
5 On/o󰀨 switch
6 Speed control dial
7 Mains cable module
8 Mains cable module lock
... FM Milling motor without speed control
... FME Milling motor with speed control (rotary wheel on housing)
... FME... Milling motor with plug-in mains cable module
... FME... DI DI Milling motor with external speed control
Unit versions