Why is my Amcor Dehumidifier not collecting water?
If your Amcor Dehumidifier isn't collecting water, it might be due to a couple of reasons. First, check if the 'water full' light is illuminated, indicating that the container needs emptying and proper re-fitting. Second, the humidistat might be set too high; try selecting a lower humidity setting or switching to continuous running mode.
Why is my Amcor HD 2000HT not extracting enough water?
Several factors can cause reduced water extraction in your Amcor Dehumidifier. The humidistat may be set to a high relative humidity; try selecting a lower setting or continuous running mode. Blocked filters can also be a culprit, so clean the washable air filter and either clean or replace the activated carbon filter. If the air is already relatively dry, a lower humidity setting or continuous running mode might help. Also, ensure the unit is operating in a heated space above 5°C, as a cold room can affect performance.
How to stop water leaking from my Amcor HD 2000HT's water tank?
Water leakage from your Amcor Dehumidifier's water tank can occur due to two main reasons. If the unit is running in temperatures below 5°C, only operate it in a heated space above this temperature. Also, if you're removing the container immediately after the unit has been running, wait a few minutes after switching it off to allow any condensation within the unit to flow into the container before removing it.
General| Brand | Amcor |
|---|---|
| Model | HD 2000HT |
| Category | Dehumidifier |
| Language | English |
To Next Page
