- 23 - Hardware Installation Process
English
7) FDD (Floppy Connector)
Please connect the floppy drive ribbon cables to FDD. It supports 360K,720K,1.2M,1.44M and
2.88Mbytes floppy disk types. The red stripe of the ribbon cable must be the same side with the Pin1.
1
34
2
33
FS
8) S_ATA0/S_ATA1 (Serial ATA Connector)
You can connect the Serial ATA device to this connector, it provides you high speed transfer rates
(150MB/sec).If you wish to use SATA0 and SATA1, please Enable " OnChip Serial ATA " item.
Then, install the correct driver to have proper operation. For details, please refer to the
"VT8237_SATA_Manual.pdf" at "http:\\www.gigabyte.com.tw"
7
1
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
FS
To Next Page
Loading...
