Amer AMR DCP100KIT - User Manual

Installation & Assembly: Universal Drop Ceiling Mount
Model Number:
AMR DCP100KIT
IMPORTANT! Read instruction sheet be-
fore you start installation and assembly.
Before you start make sure all parts listed
are included with your product.
Part # Parts Description Qty. Part Image
A M5x45 Drywall
Screw
2
Not used with 2x2 plate
B Plastic Anchor 2
Not used with 2x2 plate
C M6.5 Washer 2
Not used with 2x2 plate
D M4x16 screw 4
E M4x40 screw 4
F M6x16 screw 4
G M6x40 screw 4
H 8MM hex bolts 2
I M5x16 arm screw 4
J M5 washer 4
K S=3mm Allen
wrench
1
L S=6mm Allen
wrench
1
M M5 washer 4
N Arm 4
O Universal Spider 1
Part # Parts Description Qty. Part Image
P Mount plate 1
Q Middle Piece 1
R Ceiling Plate 1
S
Caddy® Speed Link
1
T Hold Down Clips 2
Parts List
www.amer.com For assistance, call 1-800-241-1644

Summary

Parts List

Installation Instructions

Step 1: Determine Projector Placement

Decide projector hanging location and ceiling tile orientation for best alignment.

Step 2: Route Cables and Secure Mount Plate

Select hole for wires, plug unused holes, and attach mount plate to ceiling plate with hex bolts.

Step 3: Install Y-Toggles for Ceiling Grid

Insert Y-Toggles into ceiling plate slots and wrap cable over rafter or ceiling grid.

Step 4: Secure Mount with Hold Down Clips

Push hold down clips to snap over the T-bar for secure mounting.

Step 5: Attach Projector Arms to Spider

Connect projector arms to the universal spider using provided screws and washers.

Step 6: Mount Projector to Arms

Attach the projector to the arms using appropriate screws and tighten all fasteners.

Step 7: Connect Projector Assembly to Ceiling

Hook the universal spider with the attached projector to the ceiling mount.

Adjustment Procedures

Amer AMR DCP100KIT Specifications

General

Brand	Amer
Model	AMR DCP100KIT
Category	Racks & Stands
Language	English