Need help?Do you have a question about the American Audio VLP300 and is the answer not in the manual?
Lists essential safety measures to prevent electrical shock, fire, and damage.
Details XLR and 1/4" input connectors for connecting audio sources.
Describes binding post and banana plug outputs for speaker connections.
Details speaker connection for mono bridge operation using positive terminals.
Explains using Neutrik Speakon connectors for secure stereo speaker connections.
Step-by-step guide for assembling Neutrik Speakon NL4FC connectors onto speaker wire.
Connects inputs and speakers to channels one and two independently.
Combines channels one and two for increased power output to a single speaker.
Drives both channels with the same signal for independent operation, often for bass.
Built-in limiter reduces signal overload to prevent clipping and distortion.
Guidance on safe power output levels based on speaker impedance loads.
Automatic protection that discontinues operation if a short circuit is detected.
Lists the various AC voltage and frequency options for different regions.
Specifies RMS output power per channel and bridged mode for different loads.
Measures distortion levels at specified frequencies and loads.
Defines the range of frequencies the amplifier can reproduce accurately.
Indicates the speed at which the amplifier's output voltage can change.
General| Total Harmonic Distortion (THD) | < 0.1% |
|---|---|
| Signal to Noise Ratio | > 100 dB |
| Input Impedance | 20k Ohms |
| Cooling | Fan cooled |
| Damping Factor | > 200 |
| Frequency Response | 20 Hz - 20 kHz |
| Weight | 22 lbs |
| Input Sensitivity | 0.775V |
To Next Page