- 1 -
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2018
Thank you for selecting American Standard...
the benchmark of ne quality for over 100 years.
RECOMMENDED TOOLS
M965966 Rev. 1.0 (12/18)
Edgemere
™
Pressure Balancing
Bath and Shower Trim Kit
INSTALLATION
INSTRUCTIONS
TU018500
TU018501
TU018502
TU018507
TU018508
Plumbers’ Putty
or Caulking
Adjustable Wrench Channel Locks
Phillips Screwdriver
Certied to comply with ANSI A112.18.1M
C
H
OFF
Teon Tape
Flat Blade Screwdriver
7-11/16"
(195 mm)
1-5/8" to 3-1/4"
1/2" (13 mm) I.P.S.
FINISHED FLOOR USUALLY
BETWEEN 65" AND 78"
(1651 AND 1981MM)
FINISHED WALL
18" (457 mm)
OPTIONAL
4-1/8" (108 mm)
TOP OF TUB RIM
*5-1/8" (130 mm) Ref.
4" (102 mm)
1/2" NPT
2-3/4" MAX. (69 mm)
1-3/4" MIN. (45 mm)
ROUGHING-IN DIMENSIONS
• To assure proper positioning in relation to wall.
Note roughing-in dimensions.
CARTRIDGE INSTALLATION
11
1
2
6
5
3
4
UP
To ensure that your installation proceeds smoothly-please
read these instructions carefully before you begin.
For use with shower heads rated at 4.9 L/min (1.3 gpm) or higher.
• Remove PLASTER GUARD (6)
(Keep it installed for thin wall Installation).
• Remove BONNET NUT (1) by unthreading it
Counter clockwise. Remove test CAP (2).
• Remove PROTECTIVE HOUSING (3) from
CARTRIDGE (4). Install with “UP” text on top.
• Reinstall BONNET NUT (1) onto VALVE BODY (5)
and tighten rmly with 12 Nm or 9 lbs/ft.
NOTE: Specied tightening torque
of BONNET NUT (1) is critical to
assure sealing function.
To Next Page
Need help?
General
