American Standard LEXINGTON 2037.100 User Manual (English)

To Next Page

RECOMMENDED TOOLS AND MATERIALS

Putty Knife Regular Screwdriver Adjustable Wrench Sealant Tape Measure

Hacksaw Wax Ring/Gasket Flexible Supply Tube Closet Bolts Carpenters Level

1 REMOVE OLD TOILET

a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.

b. Disconnect and remove supply line. NOTE:

If replacing valve, first shut off main water supply!

c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.

d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.

NOTE:

Mounting surface must be clean and level before new toilet is installed!

INSTALL CLOSET BOLTS

Install closet bolts in flange channel, turn 90

, and slide

into place 6" (152 mm) apart and parallel to wall.

SAVE FOR FUTURE USE

CLOSET FLANGE

CLOSET BOLTS

730403-100 Rev. C

Saniwares

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

Product names listed herein are trademarks of American Standard Inc.

NOTE:

Pictures may not exactly define contour of china and components.

LEXINGTON 1.6 GPF ONE-PIECE TOILET

Model 2037.100 Elongated with Seat

ROUGHING-IN DIMENSIONS:

NOTE:

Distance from wall to closet flange centerline (rough-in)

must be 12" (305mm) minimum.

Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product

is installed properly, please read these instructions carefully before you begin. (Certain installations may require

professional help.) Also be sure your installation conforms to local codes.

INSTALLATION

INSTRUCTIONS

INSTALL WAX SEAL

Invert toilet on floor (cushion to prevent damage), and

install wax ring evenly around waste flange (horn), with

tapered end of ring facing toilet. Apply a thin bead of

sealant around toilet base.

POSITION TOILET ON FLANGE

a. Unplug floor waste opening and install toilet on closet flange so bolts project

through mounting holes.

b. Loosely install retainer washers and nuts. Side of washers marked "THIS

SIDE UP"

must

face up!

WAX RING

SEALANT

FINISHED WALL

C/L OF OUTLET

362mm

(14-1/4)

743mm

(29-1/4)

305mm

(12)

606mm

(23-7/8)

508mm

(20)

FINISHED

FLOOR

C/L OF SUPPLY

AS REQUIRED

305mm

(12)

WASHER

NUT

FLANGE

BOLT

MTG. CLIP

Need help?

Do you have a question about the American Standard LEXINGTON 2037.100 and is the answer not in the manual?

American Standard LEXINGTON 2037.100 Specifications

General

Brand	American Standard
Model Number	2037.100
Category	Toilet
Collection	LEXINGTON
Bowl Shape	Elongated
Gallons Per Flush	1.6 gpf
Material	Vitreous China
Rough-In Size	12 inches
Bowl Height	16.5 inches
Tank Cover Included	Yes
Seat Included	No
Color	White
Flush Type	Gravity
Flush Valve Size	2 inches