EasyManua.ls Logo

AmeriFlow Water Systems Inc. ET6500 - User Manual

AmeriFlow Water Systems Inc. ET6500
17 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
07\15 RO Manual A
Owners Manual
FOR REVERSE OSMOSIS SYSTEMS
MODEL | ET6500 (P/N 10-02-1330)
Includes: Installation and Service Procedures, Specications and Operation Guidelines

Questions and Answers

  • A
    Angel OrrAug 13, 2025
    Why is there no water out of the refrigerator door from my AmeriFlow Water Systems Inc. Water Filtration Systems?
    • T
      trevorsmithAug 13, 2025
      If you're getting little to no water from your refrigerator door with your AmeriFlow Water Systems Inc. Water Filtration System, a few things could be the cause. First, the 1-quart reservoir might not be full; try holding down the dispenser handle for about 3 minutes until water flows, ensuring your R/O tank is full. It could also be due to the normal R/O process, which makes water slowly, so allow 4-12 hours for the 3-gallon storage tank to fill. Low city water pressure could be the culprit, so increase it to 40 PSI with a booster pump. Check for and repair any kinked tubing, or consider that the filters might be plugged and need replacement.
  • R
    Ryan CrossAug 16, 2025
    Why is my AmeriFlow Water Systems Inc. Water Filtration Systems continually running?
    • O
      olsonmarkAug 17, 2025
      Several factors can cause your AmeriFlow Water Systems Inc. Water Filtration System to run continually. It could be due to a shut-off valve that isn't working properly, in which case you should replace it. Low city supply water pressure can also cause this issue; increase the water pressure to 40 PSI using a pump. A faulty check valve might also be the reason, so consider replacing the check valves. If ice is being made in the refrigerator, this is normal as ice is made on demand. If the system is new, allow about two weeks for the air to bleed out.
  • R
    Richard WatsonAug 20, 2025
    What to do if ice maker is not working on my AmeriFlow Water Systems Inc. Water Filtration Systems?
    • J
      jason23Aug 20, 2025
      There are several reasons why your AmeriFlow Water Systems Inc. Water Filtration Systems ice maker might not be working. Check if the ball valve to the ice line is turned off and turn it on. Ensure the ice maker in the refrigerator is in the 'on' position. If the ice maker line is frozen, thaw it with a hair dryer, making sure you have a full tank of water before turning the ice maker on. Also, inspect the tube to the refrigerator for any kinks and repair them.
  • C
    Charles GambleAug 25, 2025
    Why does the water from my AmeriFlow Water Systems Inc. Water Filtration Systems not taste or smell right?
    • B
      Brian HunterAug 25, 2025
      If the water from your AmeriFlow Water Systems Inc. Water Filtration Systems doesn't taste or smell right, it could be due to a bad membrane; replace the membrane when it's below 75% rejection and sanitize the system. Expired filters can also cause this issue, so replace them every 6 to 12 months. If there's little water use, drain or use the entire tank every 2 weeks. The system might also need sanitizing; follow the recommended sanitizing instructions and replace the filters.
  • S
    Shawna HoodAug 28, 2025
    Why is there little water coming from the faucet of my AmeriFlow Water Systems Inc. Water Filtration Systems?
    • T
      Tammy BowmanAug 28, 2025
      If you're experiencing little water flow from the faucet of your AmeriFlow Water Systems Inc. Water Filtration Systems, several factors could be at play. The tank might be over-pressurized; when empty, the tank pressure should be between 5-12 PSI. Low incoming water pressure (below 40 PSI) can also cause this; increase the pressure to 40 PSI with a pump. If it's a new system or the filters have just been changed, remember that the system can take 4 to 12 hours to completely fill. Other potential causes include a bad check valve (replace it), a tank valve that's not open (open it), a bad storage tank (replace it, ensuring tank air pressure is between 5-12 PSI when empty), clogged filters (replace them), or a kinked tube (un-kink or replace it).
  • J
    Jennifer SmithAug 31, 2025
    What to do if the hole on faucet is leaking on my AmeriFlow Water Systems Inc. Water Filtration Systems?
    • R
      Richard JacksonAug 31, 2025
      If you notice a hole leaking on the faucet of your AmeriFlow Water Systems Inc. Water Filtration Systems, it might be due to a slipped drain clamp; align the drain clamp hole with the drainpipe hole. Another cause could be drain tube loops or dips; shorten the drain tube from the faucet until you achieve a smooth downhill flow to the drain. Lastly, a restriction in the drain tube could be the problem; disconnect the drain tube and clean out any restrictions.
  • S
    Shawn McdonaldSep 4, 2025
    Why is there a noisy drain or faucet in my AmeriFlow Water Systems Inc. Water Filtration Systems?
    • A
      Anthony SmithSep 4, 2025
      A noisy drain or faucet in your AmeriFlow Water Systems Inc. Water Filtration System can often be attributed to a couple of things. If you have an air gap faucet, a little noise is common; check the manual to ensure it's installed in the proper location and allow two weeks for the air to work out of the system. Another potential cause is the drain tube; ensure it runs continuously downhill to the drain, as loops or dips can cause noise. You can also disconnect the drain tube and clean it to remove any debris.
  • L
    lisa08Sep 8, 2025
    Why are the ice cubes cloudy or the water milky colored from my AmeriFlow Water Systems Inc. Water Filtration Systems?
    • K
      kellygraySep 8, 2025
      Cloudy ice cubes or milky colored water from your AmeriFlow Water Systems Inc. Water Filtration Systems can stem from a few reasons. A bad membrane could be the cause, so replace the membrane and sanitize the system when it's below 75% rejection. It could also be related to the water supply or the refrigerator itself. If the system is new, this is normal and should clear up within two weeks.

Summary

Tools & Materials Recommended for Normal Installation

Specifications and Limitations

Warnings

Installation Procedures

Faucet Installation

Step-by-step guide for mounting the faucet onto the sink.

Easy Tap Adapter Installation

Drain Saddle Clamp Installation

Storage Tank Preparation

Tubing Connections

System Start-Up Procedures

Filter Change Instructions

Replacement Filters - Part Numbers - Replacement Frequency

Troubleshooting Guide

Performance Data Sheet

AmeriFlow Water Systems Inc. ET6500 Specifications

General IconGeneral
BrandAmeriFlow Water Systems Inc.
ModelET6500
CategoryWater Filtration Systems
LanguageEnglish