Amewi T6REMOTE - Page 18

BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL T6
18
STANDBY MODE OF REMOTE CONTROLLER
MODE SETTINGS
Set the switches of the remote control to the normal positions (turn the switch towards where the
remote controller's cover indicates), open the remote controller to enter the standby state, and the
LED display the flight parameters and related information of the current mode, which can be
categorized by fixing-wing mode settings, helikopter mode settings and special function.
Features
Channel forw. + reverse setting
Reverse
Dual Rate
D/R
EXP curve setting
EXP
Throttle curve setting
T. Curvc
Channel mixing settings
Mixes
Flight module settings
MDL.Sel
Model category setting
MDL.Type
Servo midpoint setting
Sub.Trim
Channel forw. + reverse setting
Reverse
Dual Rate
D/R
EXP curve setting
EXP
Throttle curve setting
T.Curvc
Pitch curve setting
P.Curvc
Gyro setting
Gyro
Flight module setting
MDL.Sel
Model category setting
MDL.Type
Swash plate category settings
Swash-Tyep
Servo midpoint setting
Sub.Trim
Special Function Settings
Remote control pairing
3D switch position protection
Throttle position protection
Remote control power management
Emulator function
Restore factory settings
MODE2/MODE1 conversion
Calibrate the remote control stick
PLANE
MODUS
HELICOPTER
MODUS
Dual Rate
6-CH Flaps
5-CH Landing gear /
Gyro