AMGO A245LX - Page 13

11
1. Prepare anchor bolts (See Fig. 18).
2. Using the prescribed rotary hammer drill, and drill all the anchor holes and install the
anchor bolts. Then tighten the anchor bolts (See Fig. 19).
Note: Minimum embedment of anchors is 90mm. Torque of Anchors is 150N.m.
I. Lift the carriages up by hand and make them be locked at the same level
(See Fig. 20).
J. Install safety device and safety cable (See Fig. 21).
Fig. 20
Fig. 18
Fig. 19
71
90mm