Amica EBP 13624 E User Manual

76
Installing the oven
 The kitchen area should be dry and
aired and equipped with e󰀩cient ven-
tillation. When installing the oven, easy
access to all control elements should
be ensured.
 This is a Y–type design built–in oven,
which means that its back wall and one
side wall can be placed next to a high
piece of furniture or a wall. Coating or
veneer used on tted furniture must be
applied with a heat–resistant adhesive
(100°C). This prevents surface defor-
mation or detachment of the coating.
 Hoods should be installed according to
the manufacturer’s instructions.
 Make an opening with the dimensions
given in the diagram for the oven to be
tted.
 Make sure the mains plug is disconnec-
ted and then connect the oven to the
mains supply.
 Insert the oven completely into the ope-
ning without allowing the four screws in
the places shown in the diagram to fall
out.
INSTALLATION
Electrical connection
Important!
If the xed power supply cable is damaged,
it should be replaced at the manufacturer
or at an authorized servicing outlet, or by a
qualied person to avoid danger.
● The oven is manufactured to work with
a one-phase alternating current (230V
1N~50 Hz) and is equipped with a with
a plug including a protection contact.
● A connection socket for electricity
supply should be equipped with a
protection pin and may not be located
above the cooker. After the cooker is
positioned, it is necessary to make the
connection socket accessible to the
user.
● Before connecting the oven to the soc-
ket, check if:
- the fuse and electricity supply are able
to withstand the cooker load,
- the electricity supply is equipped with
an e󰀩cacious ground system which
meets the requirements of current stan-
dards and provisions,
- the plug is within easy reach.

Amica EBP 13624 E Specifications

General

Brand	Amica
Model	EBP 13624 E
Category	Oven
Language	English