for personal safety:
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIAN CE.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE
FROM THE POWER CORD.
EAR THING
CONNECTION
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time,letthe
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water inlet to be blocked and damage the appliance.
WARNING!
Improper connection of the equipment earthing conductor can result in the risk of an
electric shock.
Check with a qualified electrician or service representative if you are in doubt whether the
appliance is properly earthed.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the
outlet, please have a qualified electrician to install a proper outlet.
18
PLEASE HANG UP THE DRAIN HOSE EIT HER WAY OFA, B, C
φ
40mm
A
B
C
Counter
Front
Drain pipe
Drain hose hook
Close the drain hose hook to the counter
NOTE
The top of the hose
must be at a height
between
40 a nd 100cm.
Thefreeendofthe
hose must not be
immersed in water.
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making sure to
avoid bending or crimping it. Use the spec al plastic support that comes with the appliance . The top of the hose
must be at a height between 40 and 100cm. The free end of the hose must not be immersed in water to avoid the
back flow of it.
i
Please close the hydrant after us ing.
To Next Page
Loading...
Need help?
General
