10 11
1
1
Mount back plate.
Attach the back plate to a sturdy
surface minimum 0cm above ground
using the supplied 35mm screws.
Optional screw holes are located
at the top and bottom of the
back plate. (1)
Monter bakplaten.
Monter laderen på en solid overflate
minst 0cm over bakken med
de inkluderte fire 35mm skruene.
Det er 2 valgfrie hull for skruer,
oppe og nede på bakplaten. (1)
Reminder:
Make sure you
cut the cable at
least 40cm from
the inlet hole.
Tips:
Det trengs
minimum 40cm
kabel fra
inntakshullet.
x 4
40cm
2
To Next Page
Loading...
