1 TV standby button
2 PVR or (with SHIFT) AV source select
button
3 Electronic Program Guide button
4 Previous channel select button
5 Set-top box menu button
6 Back button
7 Volume up and down buttons
8 Colour navigation buttons
9 Teletext button (press and release)
and SHIFT function
10 Set-top box standby button
11 Mute button
12 Set-top box PVR transport buttons
13 Stop button
14 Information button
15 Navigation and OK buttons
16 Exit button
17 Channel up and down buttons
18 Page up and down buttons
19 Channel select buttons and text
entry
20 Subtitles button
Note: Some button functionality (e.g. PVR) may not be available on specific
models of set-top box (STB), and functionality also varies with the type of TV
service delivered by your service provider.
1. Slide the battery housing cover downwards to remove.
2. Insert 2 x AAA batteries observing the correct polarity.
3. Refit the battery housing cover.
Do not mix different types of battery or old and new batteries.
Do not use rechargeable batteries with the remote control. Do not attempt to
recharge the batteries.
Remove the batteries from the remote control if you are not going to use it for
several weeks, to avoid the risk of leakage.
Immediately remove any leaking batteries. Take care when handling leaking
batteries as they may cause burns to the skin or eyes, or other physical injuries.
Please respect your environment and any local regulations and dispose of old
batteries in a responsible manner.
When the remote control is first operated all buttons transmit commands for
the STB. The exact button function will depend on your service provider. When
pressing a remote control button point the remote control towards the front of
the STB to ensure correct operation. Do not cover the infra-red (IR) window at
the front of the STB.
When a button on the remote control is pressed, either the STB standby button
or the TV standby button (if a TV brand has been entered) will flash, depending
on which product is being controlled by the remote control.
If a button is pressed for more than 30 seconds the remote control will stop
transmitting commands to preserve battery life.
Oak Remote Control User Guide
2. Inserting batteries
1. Remote control layout
Battery information
3. Operation
1 2 3
To Next Page
Need help?
General
