Amiro S1 - Common Malfunctions and Solutions; Start Failure & Power Issues; Charging & Indicator Issues; Usage Issues

V. Table of Common Malfunctions
Problem
Possible cause
Solution
Start failure
Dead battery
Charge fully before use
End of battery life
Contact the manufacturer for
repair or replacement
Automatic power
off
No operation for more than 120
seconds
Restart the device
Dead battery
Charge fully before use
RF device electrodes not
tightly pressed against the skin
Keep RF device electrodes
tightly pressed against the skin
Inappropriate gel
AMIRO gel is recommended
Insufficient gel
Replenish gel on the face
Charging failure
Mismatched charging device
Use officially designated
charging device
Reduced infrared
light brightness
and flashing of
the stamp
Temperature control
malfunction
Please stop using the device,
switch it off and contact
after-sales service
Overheated face
High intensity
Lower intensity
RF device stays in the same
area
Slightly speed up RF device
sliding
Insufficient gel
Replenish gel on the face
Low heat
Low intensity
Increase intensity
Fast sliding of the device
Slightly reduce device sliding
Mask recognition failure
AMIRO BEAUTY freeze-drying
facial mask is recommended
Tingling caused
by current
Device not pressed against the
skin
Press the device against the skin
High intensity of EMS
Lower intensity
Redness of skin
after use
RF heat
It normally recovers soon
afterwards; please seek medical
attention if you don’t recover or
have other discomfort.