5. Intensity selection
● The device’s default intensity is 1 (1 indicator on) when first powered on; it
remembers the last intensity used when it is powered on subsequently.
● After switching on, press the [intensity button] briefly to switch intensity. The
intensities are switched in the cycle of 1-2-3-2-1-2-3, at the hint of a vibration.
● The highest level of intensity is 3 (3 indicators on) and the lowest level of intensity
is 1 (1 indicator on).
6. Power indicator
● The device does not display remaining power when powered on or in use. The
indicator of the current mode will flash quickly when the power is low to remind the
charging.
● Press the [switch/mode button] to check the [intensity/power] indicator for
remaining power when the device is powered off. 3 indicators on indicate the highest
power level and 1 indicator on indicates the lowest.
● When the device is placed on the charging base, flashing [orange] indicator of the
base indicates the device is being charged, and [green] indicator indicates the
completion of the charging.
● When charging by cable, the device's intensity indicator only shows the power level,
with 3 indicators on for the highest power level and 1 indicator on for the lowest.
7. Power reminder
● In the ON or standby modes, the current indicator will keep flashing when power is
low. Please charge immediately to ensure normal operation.
● When powered off, if the device cannot be turned on by pressing the switch/mode
button and the Level 1 indicator flashes 5 times before going out, it means the power
is low. Please charge immediately to ensure normal operation.
To Next Page
Loading...