EasyManua.ls Logo

Amitek AK235EB - Waste Disposal; Discarding Old Devices

Amitek AK235EB
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
- 23 -
2. The formation of condensed water on the outer glazing is normal at high air humidity.
Just wipe off the condensed water by using a soft cloth.
Error messages displayed on the digital display:
MESSAGE
DESCRIPTION OF ERROR
RESULT
SOLUTION
HH
Overheating (above 45°C)
or short-circuit of the
room temperature sensor
The compressor turns
on for 45 minutes and
then off for 15
minutes.
Contact the
dealer
LL
Too low temperature
Open circuit (lack of
connection with the room
temperature sensor)
The compressor turns
on for 45 minutes and
then off for 15
minutes.
Contact the
dealer
8. Waste disposal
Discarding old devices
At the end of its service life the discarded device has to be disposed in accordance with the
national regulations. It is advisable to contact a company which is specialized in waste
disposal, or just contact the local disposal service in your community.
WARNING!
To exclude any abuse and the dangers involved make the waste device unfit for use
before disposal. For that purpose disconnect device from mains supply and remove
mains connection cable from the device.
For the disposal of the device please consider and act according to the national and
local rules and regulations.

Table of Contents