21ASC 70 / 90 / 100 / 110 / 130 / 150 / 200 / 250
WORKSHOP MANUAL
RULES FOR ROAD TRANSFER
The machine is equipped with safety locks to be used for road
transfer.
When transferring the machine:
Locate cylinders as shown in homologation congura-
-
tion.
Lock cylinders (cocks, reference marks).
-
Lift dozing blade (if equipped).
-
Unlock equipment control levers shifting safety device
-
lever to lock position.
On the road follow the rules regulating trac.
INVESTIGATE JOB SITE BEFORE HAND
Clear all persons from area of operation and machine move-
ment.
Make sure worksite footing has sucient strength to rmly sup-
port the machine.
When working close to an excavation, operate the machine with
che chassis frame positioned perpendicular to the cli face, so
that the machine can more easily evacuate if the cli face col-
lapses.
Conrm that your machine is equipped with a R.O.P.S. (Roll Over
Protective Structure) cab before working in areas where there is
the possibility of falling stones or landslides.
WORKING ON SLOPES
Never go down on slopes with gearbox in neutral. You might
loose control and cause serious injuries or death.
When going down on slopes, use a low gear. In this way the en-
gine is used as brake and holds the machine without overload-
ing brakes.
When working on a slope and the warning light for fuel insuf-
cient level lights up, ll the tank immediately.
Due to machine inclination, the engine can suct air and stop
suddenly, causing a serious danger to the operator and the per-
sons behind the machine.
If the engine stops suddenly, apply brakes and lower immedi-
ately the blade to the ground.
MANUALEQUIPOSPESADOS.COM manualequipospesados@gmail.com
To Next Page
Loading...
