29ASC 70 / 90 / 100 / 110 / 130 / 150 / 200 / 250
WORKSHOP MANUAL
SUPPORT MACHINE PROPERLY
Always lower the attachment or implement to the ground before
you work on the machine. If you must work on a lifted machine
or attachment, securely support the machine or attachment.
Do not support the machine on cinder blocks, hollow tiles, or
props that may crumble under ontinuous load.
Do not work under a machine that is supported solely by a jack.
Follow the procedures in this manual.
PREVENT BURNS
After operation, the engine coolant is hot and is under pressure.
Hot water or steam are contained in the engine, radiator and
heater lines.
Skin contact with escaping hot water or steam can cause severe
burns.
Be sure to stop the engine, and let engine and radiator cool.
Slowly loosen the cap to release pressure after the system has
cooled, then remove it.
Engine oil, gear oil and hydraulic oil also become hot during op-
eration.
The engine, hoses, lines and other parts become hot as well.
Wait for the oil and components to cool before starting any
maintenance or inspection work. The hydraulic oil tank is pres-
surized. Again, be sure to release all pressure before removing
the cap.
REMOVE PAINT BEFORE WELDING OR HEATING
Avoid potentially toxic fumes and dust.
Hazardous fumes can be generated when paint is heated by
welding, soldering, or using a torch.
Do all such work outside or in a well-ventilated area.
Dispose of paint and solvent properly.
If you sand or grind paint, avoid breathing the dust.
Wear an approved respirator.
If you use solvent or paint stripper, remove stripper with soap
and water before welding. Remove solvent or paint stripper con-
tainers and other ammable material from area. Allow fumes to
disperse at least 15 minutes before welding or heating.
MANUALEQUIPOSPESADOS.COM manualequipospesados@gmail.com
To Next Page
Loading...
