Ammann ASC 130 - Page 35

31ASC 70 / 90 / 100 / 110 / 130 / 150 / 200 / 250
WORKSHOP MANUAL
PREVENT FIRES
1. Check for oil leaks:
Fuel, hydraulic oil and lubricant leaks can lead to res that
may result in serious injury.
Check for missing or loose clamps, kinked hoses, lines or
hoses that rub against each other, damaged oil-cooler, and
loose oil-cooper ange bolts, for oil leaks.
Search for leaks with a piece of cardboard.
Escaping uid under pressure can penetrate the skin caus-
ing serious injury.
Do not use your bare hand to check for oil leaks.
Tighten, repair or replace any missing, loose or damaged
clamps, lines, hoses, oil-cooler and oil cooler ange bolts.
Do not bend or strike high-pressure lines.
Never install bent or damaged lines, pipes or hoses.
2. Check for shorts:
Short circuits can cause res that may result in serious in-
jury.
Clean and tighten all electrical connections.
Check before each shift or after eight (8) hours of operation
for loose, kinked, hardened or frayed electrical cables and
wires.
Check before each shift or after eight (8) hours of operation
for missing or damaged terminal caps.
DO NOT OPERATE MACHINE if cable or wires are loose,
kinked, etc.
Tighten, repair or replace any loose or damaged electrical
cables, wires, and terminal caps before operating the ma-
chine.
3. Clean ammables:
Spilled fuel and oils, and accumulated coal dust and other
ammables may cause res and serious personal injury.
Prevent res by keeping machine clean every day.
4. Check key-start switch:
If a re breaks out, failure to stop the engine will escalate the
re, hampering re ghting. Always check key/start switch
function before operating the machine every day:
Start the engine and run it at slow idle.
-
Turn the key/start switch to the OFF position to
-
conrm that the engine stops.
If any abnormalities are found, be sure to repair them before
operating the machine.
5. Check heat shields:
Damaged or missing heat shields may lead to res. Dam-
aged or missing heat shields must be repaired or replaced
before operating the machine.
MANUALEQUIPOSPESADOS.COM manualequipospesados@gmail.com