Ammann ASC 130 - Page 42

38 ASC 70 / 90 / 100 / 110 / 130 / 150 / 200 / 250
3. Repair safety instructions
The following safety instructions must be observed by all repairing the machine!
Repairs may be carried out by skilled, trained and experienced personnel only and/or by Ammann SERVICE and dealers. •
When performing repairs, always use our shop manual. Special instructions for the assembly work are given in individual chapters
•
of the manual.
Before putting the machine into operation acquaint yourselves with the machine control as given in the “Operating instructions“
•
and make sure that you understand well all outt of the machine.
Do not use the machine if you do not fully understand all controls and until you know how the machine works.
•
Know the area where you will work.
•
Do not make any redesign or modications on the machine because you could decrease safety of the equipment.
•
Original parts and accessories have been designed especially for this machine.
•
Installation and usage of spare parts not supplied by the manufacturer of the machine or not authorized by him can have negative
•
eects on operational characteristics and safety operation of the machine.
Safety precautions when repairing and inspecting the equipment
Wear work clothe and boots. •
Use gloves when handling oils, fuel or coolant.
•
Protect your eyes with goggles or a shield when handling the battery.
•
Place the equipment on a at and rm surface before starting repair. Secure the equipment against spontaneous movement.
•
Secure the frame of the equipment and the drum against mutual rotation using a safety pin and a draw bar.
•
Before starting work remove the ignition key, disconnect the batteries and let hot parts cool down.
•
Attach a warning note “Equipment out of work“ to the steering wheel and leave it there for the duration of service work.
•
Wash the equipment thoroughly. If you use steam, do not expose electrical components and insulation directly to stem jet, or else
•
cover them beforehand.
Keep all parts absolutely clean when dismantling, mounting, and servicing each assembly. Protect removed parts from getting
•
soiled.
Clean the surface of dismantled parts and provide for adequately dust-free working conditions and a needed lay-o area.
•
Be careful when handling cleaning agents. Do not use petrol or other easy inammable materials for cleaning.
•
Dry the cleaned parts and immediately cover with anticorrosive protective oil- never install corroded parts!
•
Tools, hoists, safety equipment of the supports, and other additional items must be serviceable and in good condition.
•
Use hoists and fasteners (ropes, chains) that have sucient carrying capacity and are in good condition.
•
Make sure that there is enough fresh air supply when starting up the equipment in an enclosed area.
•
Before placing the equipment into operation make sure there nobody on the equipment or close by. The start of the equipment
•
must always be announced with an audible alarm , also after any pause in operation before the equipment is restarted. Persons
present on the equipment and dangerously close by must leave the equipment after such alarm has been sounded.
Do not adjust moving equipment.
•
When working (adjusting) on the running engine, avoid touching hot and rotating parts.. During work on the running engine,
•
another person must be present that can easily access the emergency switch and must be in contact at all times with the person
performing the adjustment, to be able to switch o the engine immediately when necessary.
Use only prescribed makes of motor, gear and hydraulic oils and coolants.
•
MANUALEQUIPOSPESADOS.COM manualequipospesados@gmail.com