20
SAFETY PRECAUTIONS
AVOID TIPPING
When operating on a slope, keep blade low to ground
and close to machine.
To avoid tipping:
- Be extra careful before operating on a grade.
- Prepare machine operating area flat by grading.
- Keep the blade low to the ground and close to
the machine.
- Reduce machine operating speed to avoid tipping
or slipping.
- Never attempt to travel across a grade steeper
than 15 degrees.
Be careful when working on frozen ground.
- Temperature increases will cause the ground to
become soft and make ground travel unstable.
DRIVE MACHINE SAFELY
Before starting the machine, read carefully the “use and
instructions manual” to get familiar with levers.
Before moving the machine, confirm which way to move
pedals/levers for the corresponding direction you wish
to go.
When traveling up or down a grade, keep the blade in
the direction of travel, approximately 20 to 30 cm (A)
above the ground.
BEWARE OF EXHAUST FUMES
Engine exhaust fumes can cause sickness or death.
If you must operate in a building, be sure there is
adequate ventilation.
Either use an exhaust pipe extension to remove the
exhaust fumes or open doors and windows to bring
enough outside air into the area.
A
MANUALEQUIPOSPESADOS.COM manualequipospesados@gmail.com
To Next Page
Loading...
